Escea IB600 Installationshandbuch PDF herunterladen (Seite 15)

G8860 _2 Installation Manual AUS

16.1

16.2 Note: If installing a flue system into a framed timber wall the outer liner should not come

down any further than onto the stand offs on the top of the OSK to allow unimpeded flow of air

between flue and liner. Please ensure the weight of the liner is supported and not all bearing

down on the OSK.

5) Replace the parts and panels that have been removed. The fire box must be completely

centralised before pushing it back into place other wise the heat exchanger will not

engage with the draft diverter at the back of the appliance.

17.0 Connecting the Gas Pipe:

When the heater has been pushed back into position the 300mm flexible braided stainless

steel gas pipe (supplied) can be connected to the inlet side of the appliance regulator at the

front RH corner of the heater. The hose and pipe assembly should have already been tested

as per section 10.2.

17.1 If the installer chooses not to use the supplied flexible inlet pipe then 12mm copper can be

run directly to heater and connected onto the regulator with flare nut (BSP thread). The

regulator that is supplied with the fire MUST NOT BE REMOVED. Removal of the regulator,

or replacing it with one not intended for use with an Escea fire, will void the limited appliance

warranty.

Flue liner should seat

onto the stand off

brackets as shown.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

Escea IB600 Installationshandbuch Seite 15